Answer: It depends. The following provides guidance on output power reporting for EMC, HAC and SAR test reports:
Grantees must coordinate with Test labs to ensure all samples for EMC, HAC and SAR are tested at maximum output conditions as required by the applicable test procedures. The output power measured for EMC and SAR may vary due to differences in test procedures and requirements. The measured values may not be directly comparable unless the same identical procedures are applied; for example, peak, average, bandwidth, modulation, operating modes, data rates and frame/bit patterns etc. It is the grantees responsibility to ensure all test samples are operating within tune-up requirements (accepted for the filing) and test results will support compliance for all production units. Although the measured output power may vary with the equipment and setup used, it is the responsibility of grantee and test labs to ensure that the devices selected for testing are in accordance with 2.907. |