TCB GRANT OF EQUIPMENT
AUTHORIZATION
TCB
Certification
Issued Under the Authority of the
Federal Communications Commission
By:

  UL Verification Services Inc. (formerly UL CCS)
47173 Benicia Street
Fremont, CA 94538
Date of Grant: 12/07/2020

Application Dated: 08/26/2020
Broadcom Corporation
270 Innovation Drive
San Jose, CA 95134
 
Attention: Anne Liang , Manager, Compliance Engineering

NOT TRANSFERABLE
EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below.
 
FCC IDENTIFIER:  QDS-BRCM1095
Name of Grantee:  Broadcom Corporation
Equipment Class: 15E 6 GHz Low Power Indoor Client
Notes: 802.11ax WLAN PCI-E Custom Combination Card
Modular Type: Limited Single Modular
Grant Notes  FCC Rule Parts Frequency
Range (MHZ)
Output
Watts
Frequency
Tolerance
Emission
Designator
EP MO 15E 6025.0  -  6985.0 0.062  

Output power listed is EIRP.

Limited modular approval. This module may only be marketed and sold to an OEM system integrator that has an agreement with the grantee and has been provided detailed instructions on installation conditions to ensure that the correct firmware is installed. Host systems must be intended for indoor use only, outdoor applications are NOT allowed.

The module grantee is responsible for providing the documentation to the system integrator on restrictions of use, for continuing compliance of the module including the maximum and minimum antenna gains and antenna type. The host integrator must follow the integration instructions provided by the module manufacturer. The host integrator installing this module into their product must ensure that the final composite product complies with the FCC requirements by a technical assessment or evaluation to the FCC rules, including the transmitter operation and should refer to guidance in KDB 996369.

To satisfy RF exposure requirements the module antennas must be installed with a minimum separation distance of 20 cm from persons. Users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.

Co-location of this module with other transmitters that operate simultaneously are required to be evaluated using the FCC multi-transmitter procedures.


EP: Output power is Effective Isotropic Radiated Power (EIRP)
MO: This Multiple Input Multiple Output (MIMO) device was evaluated for multiple transmitted signals as indicated in the filing.